The grinding machine mainly through the mixing of raw materials, rolling, crushing, rolling repeatedly after the water to achieve a balanced, uniform ratio, low gas content, improve the molding rate and molding quality, through the machine grinding material molding products, With high density, good strength, no proportion of porosity and other characteristics. Efficient energy-saving, high output, the product is used in the iron ore process in the tailings for recycling, so that the loss of slag, so that effective use of resources can be fully utilized.

Grinding machine in the election of gold when the selection method and process:
1. Grinding machine after the installation and commissioning to the bottom of the grinder to add about 5 kg of mercury began to work properly.
2. Each class to receive a Sands, in the shift by adding 1 kg of mercury to receive the bottom of the sand and mercury, the mercury received gold in the device, with a relatively high density of red cloth to the package to screw out, open the red The left is the sand.
3. You can add one kilogram of mercury to each class. Containing a gold cloth or caught gold blanket and then put the mercury plate can be charged gold.

1.The raw material should be put into the machine after the machine running normally. 
2.This machine is not allowed to state with the material in the machine. If the machine is stopped because of stoppage, the residual material in the machine should be cleared. Then start the machine again.
3.The material should be put into the machine uniformity, not sometimes much sometimes less. It's better to use a feeding equipment.
4.The bearing part should be add butter regularly.
5.Every bolts should be checked to avoid flexible.
6.The bearing should be changed in time if it is damaged to avoid damage other parts.